Winterizing your above-ground pool requires you to drain the sand filter and the pump. Winterization also requires you to disconnect the hoses for the pool, pump and filter. Once the winter is over, and the outdoor temperatures begin to rise, it is time to reopen the pool for the summer. Trying to remember where each of the three hoses attach to your filter, pool and pump can quickly spell disaster if you mix up the connections. Correctly hook up your sand filter and pump to your above-ground pool for hours of summer fun. Place the sand filter close to the pump.
How Do You Hook up Hoses to a Pool Pump and Filter?
How To Hook Up An Above Ground Pool Filter System | Wet Head Media
Select Page: Where to? There will be several things that you will need to connect to get your above ground swimming pool filter set up and running for the pool season. You will first need to locate all the parts that were put away when you closed your swimming pool. In order to connect the skimmer to the pump you will need to take one of the pool hose and put a hose clamp on each end.
I remember it well. Using just a map, I drove way out to the other side of Lake County to a small house that looked like a shack. It seemed to me that I was always building pools way out in the boonies. And it was always the last house on the right. As you can imagine, this place was way out in the middle of nothing.
For that reason, you need to clean your above-ground pool with a pool vacuum at least once a week. Pool vacuum setup takes only minutes, but you need to know the proper way to hook up the vacuum; otherwise, you might not get proper suction for the vacuum to do its job. Push the telescoping poles of the vacuum head together until you hear them click. Push the swivel end of the vacuum hose onto the vacuum head.